Lorex Technology SG17L7584 Uživatelský manuál stáhnout pdf (Strana 45)

Connecting Motion / Alarm Device - Appendix #6

Motion detection and Alarm controls are enabled through the Menu system on the Observation

System. Additional motion sensor devices can be connected to the system (Motion Sensors,

Door/Window Sensors).

OBSERVATION SYSTEM

SENSOR

(Not Included)

A motion detection or sensor unit can

be used to send a signal to the

Observation System to begin camera

viewing on the matching Video

Channel (when enabled in the

MENU/ALARM SET MODE)

• Example: A Window sensor unit

has been installed on Alarm

Block port #4. When this sensor

is activated, the camera on DIN

or BNC VIDEO port #4 will

become active (if enabled in the

MENU on the Observation

System)

For the corresponding Menu Pro-

gramming, refer to Page 26.

Installing a Sensor

1. Connect the GROUND Cable to the

GND port on the Alarm Block on the

Observation System

2. Connect the SIGNAL Cable to a

numbered port (1-8)

To start ALARM RECORDING on a

DVR unit, refer to the manual for

your specific DVR product.

1 2 ... 40 41 42 43 44 45 46 47 48 49

Žádné komentáře

Lorex Technology SG17L7584 Uživatelský manuál Strana 45